60W Redundant Power Supply (DPS-200)
$309.99 CAD$619.99 CAD
Availability: 
In stock
  • Redundant Power Supply - When the DES-3010PA is equipped with the DPS-200, both power supplies are switched on and share the current load. In case the power supply of the DES-3010PA should fail, the DPS-200 will instantaneously take 100% of the load without any loss.

AC Input Voltage Rating

  • 100VAC to 240VAC

AC Input Voltage Range

  • 90VAC to 264VAC

AC Input Frequency Range

  • 47 Hz to 63 Hz

AC Input Current

  • 1.6A (RMS) max. for 115VAC
  • 0.8A (RMS) max. for 230VAC

Maximum In-rush Current

  • 30A max. @ 115VAC (at 25º C ambient cold start)
  • 60A max. @ 230VAC (at 25º C ambient cold start)

Leakage Current

  • 3.5mA max.

Output Voltage

  • +12VDC

Minimum Load Current

  • 0.5A

Maximum Load Current

  • 5.0A

Line Regulation

  • +/-2% (measured output load from +/-10% rated load)

Load Regulation

  • +/-5% (measured output load from 20% to 100% rated load)

Output Ripple & Noise

  • 120mV (measured bandwidth oscilloscope and terminated each output with 100uF capacitor and 0.1uF ceramic in parallel)

Total Output Power

  • 60 watts

Efficiency

  • 75% min. @ max. load and 115VAC input

Hold Up Time

  • 16mS min. at max. load and 115VAC input, @ 60Hz output drop down to 95% output voltage

Over Current Protection

  • Power supply protected against overload and short circuit applied to any one terminal - auto restart * *Output can be shorted permanently with damage

Over Voltage Protection

  • 13.5V to 17V

AC Power Good (pwr-good)
Signal Required

  • +3.3V *
    *(1) Minimum high voltage is 2.0V with a maximum load current of 5.0mA
      (2) Maximum high voltage is 3.4V
      (3) Minimum low voltage is 0.0V
      (4) Power good signal must go low within 0.5ms before 12V output drops out of below 10.0V
      (5) Power good signal must go high within 2.5 seconds of application of power to the system

LED Status

  • On: RPS good
  • Off: RPS failed

Dimensions

  • 127mm (L) x 76mm (W) x 37mm (H)

Weight

  • 0.83 kg

Operating Altitude

  • 3,000 m (10,000 feet) max.

Storage Altitude

  • 12,000 m (40,000 feet) max.

Operating Temperature

  • 0° to 50° C

Storage Temperature

  • -20°  to 80° C

Safety Standards

  • -CSA

EMI

  • FCC Class B
  • EN55022 (CISPR22) Class B

HI-POT Test

  • Input to secondary: 3000VAC for 1 minute, 10mA
  • Input to P.E.: 1500VAC for 1 minute, 10mA

Insulation Resistance

  • Input to secondary: >20Mohm 500VDC

Reliability (MTBF)

  • 50K Hrs Min. at 25 degrees C 240VAC (max load)

Shock & Vibration

  • 10-55Hz, amplitude 2G over entire frequency range. Sweep minute for X, Y and Z axis each 20 cycles.

MTBF

  • 71,713 hours